|
|
|
Features
|
|
Work Zone
ChemFiller
The HARDI ChemFiller is standard on the COMMANDER and has been developed to handle large quantities of powders and liquids. The high capacity of the ChemFiller is achieved by using a combination of high vacuum and high pressure vortex nozzles placed inside the hopper.
High capacity Vortex action inside hopper.
Liquid at high pressure is used to create a powerful vortex inside the hopper. This vortex will efficiently mix all powder and liquid chemicals before they are transferred into the sprayer.
Very high vacuum and suction capacity.
A large external ejector system creates a powerful vacuum that transfers powders and liquid directly into the tank.
The sturdy lid can be used as work table.
When the lid is opened, it can be used as a bench for measuring or storing the chemicals before mixing.
Rotating nozzle used for cleaning containers and the ChemFiller itself.
The built-in rotating nozzle will clean any chemical container. After use the same nozzle will clean out the complete ChemFiller. The nozzle has a point that can penetrate the seal on most chemical containers.
Filling capacity liquid up to 32 gpm.
Size of hopper 9 gal.
|
SmartValve
All primary functions needed to operate the sprayer when filling or cleaning have been built into two handles located in the center of the work zone. The logically placed handles and the easy to read color coded icons make the system very easy to understand and operate. This greatly reduces the start-up and operation time of the sprayer. |
Suspended drawbar
The drawbar on COMMANDER 6600, 8500 and 10000 are as standard fully suspended.
The full up and down load from the sprayer to the tractor and transferred through rubber dampers built into the chassis. The drawbar on COMMANDER 6600 and 10000 furthermore has a hydraulic support leg as standard.
The hydraulic support leg is driven by a separate hydraulic outlet on the tractor and ensures easy and safe attachment of the sprayer |
Suspended axle
Strong hydraulic cylinders absorb shock loads instead of transferring them to the boom and tractor. This ensures operator comfort and optimises application at even higher speeds.
-
Compact suspension system permits track width down to 60 inchs with tires up to 13.6 inchs wide.
-
Suspension range 4400 - 17630 lbs.
-
High comfort level at high driving and spraying speeds
-
Suspension is adjusted to match tank and boom size from the factory
-
Suspension does not compromise the clearance.
|
Agitation
Because of the forward sloping of the tank, agitation towards the sump is very effective. The agitation is infinitely variable to match the different viscosities of the spray liquid. |
Bottom suction
Very deep central tank sump.
The sprayer is completely emptied even on slopes up to 15 degrees - uphill or downhill |
Tank cleaning
Easy to rinse inside with tank rinsing nozzles.
100% of the tank can be “seen” by the rinsing nozzles. No sharp corners prevent sedimentation of pesticide. |
Liquid system
EasyClean filter
The new HARDI EasyClean suction filter is a high capacity filter with a very large filter surface.
The condition of the filter can be constantly monitored on an external gauge. This ensures that the filter is cleaned when needed and only when needed.
When opening the lid, the main valve is automatically turned to OFF. The automatic shut off valve ensures safe operation of the sprayer, without any risk of spill.
|
CycloneFilter
The new HARDI CycloneFilter is a unique self-cleaning pressure filter that uses a high-speed cyclone for additional cleaning action. The cyclone action increases the cleaning capacity of the filter significantly. This ensures fewer stops and reduced pressure loss in the liquid system. The HARDI CycloneFilter furthermore has a unique boost function that allows the filter to be flushed "on-the-go" when needed. |
PrimeFlow
-
The controls are at the nozzle
-
Prevents sedimentation
-
Flushes boom lines without spraying
-
Pressure based system for trouble-free operation
-
Up to 13 sections are possible
-
Nozzles per boom section are freely configured
|
ACE 650 Oasis "Wet Seal" centrifugal pump
-
Hydraulic drive
-
The Oasis™ WetSeal system prevents run dry and abrasive wear seal failures by isolating seals from the pumped liquid
-
The innovative impeller design provides higher pressure (up to 160 PSI) and more consistent pressure over the entire flow range.
|
AutoWash
-
Choose a program and the rest is automatic
-
Operator and tractor cabin not contaminated
-
Time saved as process is done from the tractor cab
-
Effective controlled cleaning so pesticide cross-contamination avoided
-
No residues at end of spray task
-
3 programs from 1 to 15 minutes
-BoomFlush
-FastFlush
-MultiRinse
|
AutoFill
-
Eases tank filling process
-
Other tasks can be done
-
Can set own volume
-
Safety – no overfilling
-
Start/Stop control is at the Fluid- Box near the work area
-
Capacity: 160 to 210 gpm
-
Approximately 5½ to 7 minutes to fill 1100 gallons
|
EAGLE 80 to 100 feet
The HARDI EAGLE boom is top of the line in medium scale conventional spraying available in 80 to 100 feet. The HARDI EAGLE is the perfect choice for small to medium-scale farmers and contractors looking for unmatched performance and dependability. |
FORCE 80 to 132 feet
The HARDI FORCE boom is top of the line in conventional spraying, available in 80 to 132 feet. The HARDI FORCE is the perfect choice for large-scale farmers and contractors looking for unmatched performance and dependability. The rugged three-dimensional structure guarantees unrivalled durability. |
TWIN FORCE
The HARDI TWIN booms offer the ultimate in capacity, weather independence and application technology. The ideal high capacity solution for most users. The TWIN is available in sizes from 80 to 118 feet. |
AutoHeight
The NORACI AutoHeight system gives full control of the boom, which means automatic operation of height and tilt functions. This gives the driver easier control of the boom and better spray application.
Operator relief
With the HARDI AutoHeight system, the boom automatically follows the field contours of the land. The system relieves the operator from the stress of monitoring field contours and making constant boom height adjustments. The sprayer pilot no longer has to move his head from side to side for many hours which mean that the system frees the operator from the most stressful part of the job. This also allows the operator to increase the travel speed and extend application time well into the night to take advantage of low wind conditions. |
HC 6500
The HC 6500 is designed specifically for spraying Multi-purpose computers often compromise on detail as they miss the specifics a sprayer specialist holds. The more complex a product, the simpler it should be to use.
HC 6500 is easy to use and is a natural choice for EAGLE, FORCE, TERRA FORCE and TWIN FORCE booms and there is a growing list of intelligent options that can be added.
Intuitive controls The operator has the best possible man-machine interface for spraying The grip is the primary control and it can be placed close to the operator It holds all the most used functions. |
ISOBUS compatible
The HARDI COMMANDER i sprayer can be operated with a virtual ISOBUS terminal. To make the complex sprayer operation easier, the proven HARDI GRIP will be delivered with the COMMANDER i sprayer so all primary spray functions, such as on/off and section switches as well as the hydraulic operation can easily and safely take place by means of a joystick. Also a SetBox will be used to operate sprayer specific equipment as TWIN air assistance or SafeTrack steering directly.
Integrated AutoSectionControl
If the existing Virtual terminal has an automatic section control, following the de-fined task controller function of the ISOBUS standard, for example the John Deere Sprayer Pro, the ISOBUS terminal can operate the distribution valves of the COMMANDER, so the customer does not need a separate HARDI AutoSec-tionControl.
Updating
Existing COMMANDER i sprayers can be updated to an ISOBUS sprayer. That is also possible for sprayers which will now be ordered with the HARDI CONTROLLER 6500. The customer only has to buy the ISOBUS bridge, so the ISOBUS terminal can communicate with the HARDI jobcom. |
Address:
