DH3 Cutterbar: Cutterbar Improvements for Greater Operational Efficiency
Frame
• Tube design angled for increased strength and visibility
• Draper angle decreased from 20 degrees to 15 degrees for improved feeding and visibility
Ground Cutting and Crop Feeding
• Low profile bottom for close-to-ground cutting at lesser guard angle (7/8" at 2 degrees of tilt)
• Shallow-angled top section for improved crop feeding and reel cleaning
Cutting System
• Case IH cutting system with new raised style knife head (Shown)
• Schumacher cutting system (Shown)
• Case IH stub guard cutting system
Draper Deck
• Double V-Guide drapers for double life (reversible) and edge seal to keep trash out
• Improved deck sliding by shifting decks on UHMW blocks with added space to allow material to clean out
• Drive rollers at inside end of drapers for increased traction
Draper Deck Modifications
• Deck sizes standard between SSW and DSW units. Only difference being the end tin (2" wider on DSW units allowing opening to be made 4" smaller)
• 72" to 60" adjustable center-delivery heads
• 72" to 56" adjustable on double-swath heads
• Rear opening can be increased to 80" by removing back panel extensions
Gauge Wheel Configuration
• Coil spring-over-shock absorber
• Quick adjust design
• Provides superior ground following and float
• Increased strength in control arm
• New Crop dividers, with adjustable angle and interchageable ends (pipe and cone), are simple to install and reduce trampling.
|